Home > News > Content
Proper Selection Of Installation Location Of Cooling Tower
Nov 30, 2018

The purpose of selecting the correct installation location of the cooling tower is to ensure that the cooling tower can enter the unit freely and without obstacles when fresh air is fresh, and to ensure that the location of minimizing reflux.In the design phase, the focus should be on space constraints, surrounding buildings, existing units, adjacent buildings, dominant wind direction, pipelines and possible future expansion plans.After mastering these data, the optimal installation location of sewage cooling tower can be selected correctly.Specific matters needing attention:

1. Generally, the cooling tower in the factory is installed on the roof or on the floor of other buildings with sufficient bearing capacity, because it has a good ventilation effect and can better help the cooling tower dissipate heat.

Note: during installation, the shortest distance between the air inlet of the cooling tower and the building should not be less than 1.5 times of the outer diameter of the tower body, so that fresh air can enter the tower unimpeded, avoid installation in the high wall without ventilation;

2. When one cooling tower cannot meet the production demand, more cooling towers need to be installed. At this time, attention should be paid to the spacing between each cooling tower to ensure smooth ventilation;

3, cooling tower installation location choice, must pay attention to whether there will be soot or dust around the place, to avoid installation in these places, to prevent the film is blocked by soot dust;

4, in the installation, if there is a kitchen or other boiler room and other hot places, should be re-selected address, these places are easy to produce heat, resulting in the cooling tower itself heat dissipation, cooling capacity is poor.