Home > News > Content
Cooling Tower Repair And Maintenance(1)
Oct 20, 2017

When the cooling tower is put into operation, it must be managed by a special person, periodically checking the operation and maintenance and take notes,and pay attention to the following points:

1.Cooling tower inlet water must be clean,beware of the iron slag, dirt, sundry of installation,so as to avoid sticking water distribution pipeline,influence water distribution effect, if the above situation appeared,please clean it in time.

2.Circulating water suspended solids content, general control under 50 mg/L, when turbid concentration growth, properly add a small amount of bleach or other water treatment agent for processing, avoid dirt and moss in the long time running.

3.The motor end cover should be kept refuel one time every year: the speed reducer must be kept strictly with no oil running, and the general industrial gear oil 20# ~ 50# should be added in time, and the new oil should be replaced after six months of continuous operation.  

4.If the fan system has unusual phenomenon,should stop the tower in time to check,trouble shooting,make sure the cooling tower is in good running condition.

5.When the cooling tower is in use, if the water loss is excessive, the replenishment device should be used in time to replenish water。  

6.It is required to wash the tower inside and outside once a year to prevent the dirt and water influence the inlet and outlet water.   

7.The cooling tower fan should be started before start the cooling tower, avoid the motor current load overload and damage if start the tower first.When in winter the cooling tower stop running should repair and maintenance, and take moisture-proof measures.

8.After the cooling tower stop running,should let out all the water in the tower and pipeline,and take a complete overhaul to the whole tower,ensure the next running is safe and normal.

9.When use the cooling tower after a long time stop,must operate according to operation instructions.